ZlideOn Waterproof Zipper#L (black)

Specifications

• Zipper type: Waterproof
• Width: 6.40 – 6.60 mm (zip teeth when meshed together)
• Height: 2.60 – 2.70 mm (zip teeth)

Instructions

• Step 1 First remove the old zipper-slider. This can be done in several ways. One way is to cut it in the middle with a wire cutter.
• Step 2 Ensure the ZlideOn is open. Open the ZlideOn holding the bottom part still and pull back the puller as far back as possible. Do not bend it open with a screwdriver or similar as this may prevent ZlideOn from working as it should.
• Step 3 Put the ZlideOn on to the zipper. If the zipper is closed somewhere, put it over the zipper where the zip teeth have meshed. If the zipper is fully undone, clip the ZlideOn to the starter box, then slide the insertion pin into the starter box.
• Step 4 Close the ZlideOn pressing the top and bottom part of the ZlideOn together with your fingers. Now your Zipper is repaired and you are ready to go!

Additional information

Brand	ZlideOn